The first step for the brake bracket is to model it in inventor. I just had to copy it from the sketches and then dimension it correctly and I would be fine. After you gave designed it in inventor, you move onto Fusion 360. Everything is the same except for the measurements and the type of cutting you use. You use 3D- adaptive clearing, unlike the maze which was 2D- Contour. Once you've finished that you go down and cut it out using the CNC Mill. After that, just like the maze, you have to use the laser to engrave your name onto you bracket. Then you're finished.
In this project I learned about the CNC Mill. I already used Fusion 360 for the maze, so it wasn't a new software but it was a newer software. The mill was smaller than the router and it was easier to handle. I didn't run into any problems so that leads me to believe that I did everything correctly and that I learned everything I needed to know from the project.